Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 25 / 40

Molynx protocol – Fixed at 9600,E,8,1 Control from BBV and Pelco D/P protocol only

Function TX1500 Procedure Pelco Procedure

PRESET 1 – 32 As manual As manual

WASH, WIPE, LIGHTS As manual As manual

TOGGLE MENU ON/OFF 1 # Go to Preset 61

TOGGLE JOYSTICK

PTZ/MENU CONTROL

2 # Go to Preset 62

SET IN MENU IRIS OPEN or 3 # Go to Preset 63

DEFINE PRESET PATROL 4# Go to Preset 64

RESET RECEIVER PROGRAM 99 PRESET Program 99 Preset

Notes:

Connect receiver + to the BBV 1-2-1 converter TA and receiver - to the BBV 1-2-1 converter TB.

Set the receiver address switches to match the number of the camera input of the matrix.

Molynx receivers can only be controlled when using BBV telemetry into the 1-2-1 converter ie from the BBV

TX1500 or FBM series matrix.

Control of the receiver auxiliary relays is possible using the matrix Wash, Wipe and Lights keys.

Up to 32 preset positions can be programmed and recalled.

Dome mono/colour selection is possible using the LIGHTS button once the mono/colour switching has

been set to MAN in the dome menu.

Preset Patrol Definition.

A single preset patrol can be defined which can contain up to 16 preset positions. The patrol speed and

delay can be programmed as a global for each preset position. Use the following keystrokes.

1 – 32 PRESET This is the delay in seconds for all preset positions

1 – 32 PRESET This is the speed to move between preset positions

1 is very slow and 32 is full speed

Next up to 16 preset positions, eg for patrol presets 1, 3, 6 and 17

1 PRESET, 3 PRESET, 6 PRESET, 17 PRESET

MOVE JOYSTICK This ends the definition.

To start the preset patrol press 1 PATROL

Improvement added in Version 30

SW4/8 can be used to allow the CAMERA POWER Aux to be operated from AUTOPAN allowing

AUTOPAN control of AC receivers.

SW4/8 ON = enabled this feature, and SW4/8 OFF = disables

SW4