Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 26 / 40
NIO D86/Intercepter (PELCO D) from BBV and Pelco D/P telemetry only
Connect the twisted pair as follows:
dome A+ to BBV 1-2-1 converter TA
dome B- to BBV 1-2-1 converter TB
Dome SW3 – Address, set to match the matrix camera input
Dome SW4 – 1 & 8 ON, 2-7 OFF, Selects PELCO & 9600 BAUD
The following functionality is provided.
Variable speed Pan/Tilt
Zoom/Focus/Iris
64 preset positions.
Menu access and navigation
Pattern record and playback
Tour 1 (preset patrol)
Autoscan (pan between limits)
Additional Dome features
Dome Function TX1000 Keystroke TX1500 Keystroke Pelco Procedure
DISPLAY DOME MENU
hold # and tap WASH
and navigate using the
joystick and IRIS keys
1 # and navigate using the
Joystick and IRIS keys
Go to Preset 61
PATTERN RECORD START
hold # and tap
AUTOPAN then use
joystick to move dome
around required scenes.
3 # then use joystick to move
dome around the required
scenes.
Go to Preset 63
PATTERN RECORD STOP hold # and tap LIGHTS
4 #
Go to Preset 64
PATTERN PLAYBACK
AUTOPAN AUTOPAN
Go to Preset 68
TOUR PLAYBACK hold PATROL and tap 1
1 PATROL
Go to Preset 66
AUTOSCAN PLAYBACK hold PATROL and tap 2
2 PATROL
Go to Preset 67
Note:
PATTERN
The dome pan/tilt/zoom will move through a defined movement.
Define the pattern first by 3#, then move the dome to view the required areas. Once finished 4# to end the
definition. Press AUTOPAN to playback the pattern.
TOUR
This is a sequence of preset positions that the dome moves through. The tour is defined from within the
dome menu.
AUTOSCAN
The dome will pan continually between two positions that are defined from within the dome menu.
For more information please refer to the dome handbook.
SW4