Manualshelf

Installation guide

ManualsBrandsBBV ManualsAmplifierTX1500/BBUS-IF
21222324252627282930
BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 27 / 40
PANASONIC WV-CS850/860 (adjust SW3 to suit input protocol)
Function
TX1000
Procedure
TX1500
Procedure
Molynx
Pelco &
Mark Mercer
Procedure
Show/Hide dome Menu # WASH 1 # Cam on then Prog preset 1 Go to Preset 61
ENTER (whilst in menu) # WIPE 2 # Cam on then Prog preset 2 Go to Preset 62
ESCAPE (whilst in menu) # AUTOPAN 3 # Cam on then Prog preset 3 Go to Preset 63
SPECIAL2 (whilst in menu) # LIGHTS 4 # Cam on then Prog preset 4 Go to Preset 64
Send PATROL RUN PATROL 1 1 PATROL Cam on then Goto preset 5 Go to Preset 66
Send PATROL RUN to ALL
DOMES
PATROL 2 2 PATROL Cam on then Goto preset 6 Go to Preset 67
Send AUTOPAN AUTOPAN AUTOPAN Cam on then Goto Preset 7 Go to Preset 68
BW MODE ON N/A 89 PRESET Cam on then Goto preset 8 Go to Preset 89
BW MODE OFF N/A 88 PRESET Cam on then Goto preset 9 Go to Preset 88
BW MODE AUTO N/A 87 PRESET Cam on then Goto Preset 10 Go to Preset 87
Switch and dome settings:
Ensure that each dome is configured BEFORE installation.
Output baud rate must be set to 19200,N,8,1 with SW4.
The dome must be set to Panasonic CONVENTIONAL protocol and the address set accordingly.
The 4 way dome switch must be set to 4 wire telemetry with switches 2,3,4 OFF. The RS485 cable
requires termination at the end of the run by setting switch 1 ON.
The Panasonic CS850/860 protocol conversion is only available when controlled using BBV RS485
telemetry or Molynx. If another input protocol is selected using SW3 then the unit will not function and all
the LEDs will flash until BBV protocol is selected again.
Due to protocol issues, the response of an individual dome may become sluggish if several domes are
controlled simultaneously.
Connect TA to RA (green) and TB to RB (yellow).
Note:
When working with the TX1000 SW4/8 must be turned ON.
*To use this function firstly hilite and select”camera on “”** SET UP MENU**” screen
Then hilite “RET” on “**SET UP**” screen.
Finally pan right to hilite “Special 2”
9600,N,8,1 or 19200,N,8,1