Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 33 / 40
VCL TP – Fixed at 9600,N,8,1 (adjust SW3 to suit input protocol)
Advanced Function TX1500 Procedure Molynx
Program a privacy zone
2 # followed by
PROGRAM 1-28 PRESET
Cam on then
Prog preset 2
Clear a privacy zone
3 # followed by
PROGRAM 1-28 PRESET
Cam on then
Prog preset 3
Dome remote reset (power cycle)
4 #
Cam on then
Prog preset 4
Add preset position to the tours
Programming a preset position adds the
preset into the tour. (1 – 16 only)
Remove a preset from the tours
PROGRAM 50 PRESET followed by
1-16 PRESET
Cam on then
Prog preset 13
Start preset tour 1 – high speed
1 PATROL
(max speed with 10 second dwell)
Cam on then
Goto preset 5
Start preset tour 2 – slow speed
2 PATROL
(speed 32 with 10 second dwell)
Cam on then
Goto preset 6
Start Learned tour 5
AUTOPAN (must be defined with
PROGRAM 56 PRESET as below)
Cam on then
Goto preset 7
Set Home functions
(fixed at 5 minutes)
PROGRAM 54 PRESET followed by
1 PRESET = Enable to preset 1
2 PRESET = Enable to tour 1 (fast)
3 PRESET = Enable to tour 2 (slow)
4 PRESET = Enable to learned tour
(autopan)
5 PRESET = Disable home
Cam on then
Goto preset 8
Reset dome to factory. USE CAUTION!!
This command will clear all dome
configuration including preset positions.
PROGRAM 55 PRESET followed by
PROGRAM 55 PRESET
Cam on then
Goto preset 9
Define learned tour 5 – START
PROGRAM 56 PRESET
Cam on then
Goto preset 10
Define learned tour 5 – STOP
PROGRAM 57 PRESET
Cam on then
Goto preset 11
Enable AUTO180 pan flip
PROGRAM 58 PRESET
Cam on then
Goto preset 12
SW4
Connect dome
D+ to 1-2-1 BBV Converter TA and dome
D- to 1-2-1 BBV Converter TB.
Set the dome address using the DIL switch to match the number of the camera input of the TX1500. Ensure
that any dome at the end of a daisy chained RS485 run are have the RS485 terminated and the intermediate
domes have the RS485 de-terminated.
The following functionality is provided.
Manual pan/tilt control with 16 speed steps from 1 to 127, (slowest to fastest)
Zoom with Manual Iris and Focus override.
Operating the Zoom will re-enable auto focus and iris after manual adjustment
32 preset positions.
2 sequential preset tours of preset positions 1 - 16, tour 1 maximum speed and tour 2 speed 32. The dwell
time is fixed at 10 seconds per preset position. Preset positions can be removed from the tours.
All 28 privacy zones can be programmed and disabled if required.