Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 34 / 40
VCL TP – When using Pelco input protocol
Advanced Function Pelco & Mark Mercer procedure
180 degree pan flip (U turn)
SAVE PRESET 95
Program a privacy zone
GOTO PRESET 33 followed by
PROGRAM 1-28 PRESET
Clear a privacy zone
GOTO PRESET 94 followed by
PROGRAM 1-28 PRESET
Dome remote reset
(power cycle)
Head reset
Add preset position to the tours
Saving a preset position adds the preset into the tour. (1 – 16
only)
Remove a preset from the tours
PROGRAM 50 PRESET followed by
GOTO PRESET 1-16
Start preset tour 1 – high speed
GOTO PRESET 97 (max speed with 10 second dwell)
Start preset tour 2 – slow speed
GOTO PRESET 98 (speed 32 with 10 second dwell)
Start Learned tour 5
GOTO PRESET 99 (must be defined with SAVE PRESET 56 as
below)
Set Home functions
(fixed at 5 minutes)
PROGRAM 54 PRESET followed by
GOTO PRESET 1 = Enable to preset 1
GOTO PRESET 2 = Enable to tour 1 (fast)
GOTO PRESET 3 = Enable to tour 2 (slow)
GOTO PRESET 4 = Enable to learned tour (PRESET 99)
GOTO PRESET 5 = Disable home
Reset dome to factory. USE
CAUTION!!
This command will clear all dome
configuration including preset
positions.
SAVE PRESET 55 followed by
SAVE PRESET 55
Define learned tour 5 – START
SAVE PRESET 56
Define learned tour 5 – STOP
SAVE PRESET 57
Enable AUTO180 pan flip
SAVE PRESET 58
VCL TP – from 360 Vision Protocol
From 360 Vision matrix, connect Data+ to solid blue wire into BBV 1-2-1 converter and Data- to white/blue
wire into BBV 1-2-1 converter. Connect dome D+ to STAR TA and dome D- to STAR TB.
Set the dome address using the DIL switch to match the number of the camera input of the matrix. Ensure
that any dome at the end of a daisy chained RS485 run are have the RS485 terminated and the
intermediate domes have the RS485 un-terminated.
The following functionality is provided.
Pan/Tilt/Zoom/Focus/Iris
Auto/Manual Focus and Iris switching
127 preset positions
Tour 1-4 definition and playback, preset 1-127 and dwell of 2-254 seconds (2 second increments)
Mimic Tour 1-4 definition and playback (VCL tour 5-8)
Privacy zones 1-28 can be programmed and toggled ON/OFF (VCL preset 100-127)
180 degree flip enable/disable on tilt down
Home functions, preset 1-127 or tour 1-4 with 1-127 minute delay
A1 and A2 toggle dome mono/colour but dome will auto switch back to colour if the scene if bright enough.
LOCK A3 – toggles Wiper ON/OFF (in CONV1_V24 and later software)
Please read the 360 Vision keyboard manual for details of keystrokes etc.
SW3 SW4