Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 37 / 40
VIDECON VHSD 860 DOME (adjust SW3 to suit input protocol)
Connect the twisted pair as follows:
Dome D+ to BBV 1-2-1 converter TA
Dome D- to BBV 1-2-1 converter TB
The following functionality is provided:
Variable speed Pan/Tilt
Zoom/Focus/Iris
64 preset positions
Menu Access (Iris open – Enter Iris Close – Exit)
Privacy Menu Access
Pattern Tour 1 define and playback, Auto Patrol playback, Frame Scan playback
Advanced Dome features
Dome Function TX1000 Keystroke TX1500 Keystroke
Molynx
Pelco & Mark Mercer
Procedure
DISPLAY MENU
hold # and tap WASH
1 #
Cam on then
Prog Preset 1
Go to Preset 61
DISPLAY PRIVACY
MENU
hold # and tap WASH
2 #
Cam on then
Prog Preset 2
Go to Preset 62
DEFINE PATTERN 1
START
hold # and tap
AUTOPAN
3 #
Cam on then
Prog Preset 3
Go to Preset 63
DEFINE PATTERN 1
STOP
hold # and tap
LIGHTS
4 #
Cam on
then
Prog Preset 4
Go to Preset 64
PATTERN 1 PLAYBACK
AUTOPAN
AUTOPAN
Cam on
then Goto 5 Go to Preset 68
AUTO PATROL
PLAYBACK *
hold PATROL and
tap 1
1 PATROL
Cam on
then Goto 6
Go to Preset 66
Not supported in
Mark Mercer
FRAME SCAN
PLAYBACK
hold PATROL and
tap 2
2 PATROL
Cam on
then Goto 7
Go to Preset 67
Not supported in
Mark Mercer
IR FILTER ON/OFF Not possible
ON (MONO) 89
PRESET
OFF (COLOUR) 88
PRESET
Cam on
then Prog 8 – off
Cam on
then Prog 9 - on
ON (MONO) Go to 89
Preset
OFF (COLOUR) Go to 88
Preset
Not supported in
Mark Mercer
Note:
Please ensure the three dome switches are set as follows:
Dome back plate 4 way switch – ALL OFF to select PELCO P
Dome 2 way switch – BOTH ON to select 9600 BAUD
Dome 8 way switch – set the address to match the camera input of the matrix
*Please note Auto Patrol Playback outputs goto preset 70 but our dome does nothing.
For more information please refer to the dome handbook.
SW4