Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 5 / 40
SW1
RS422/485
INPUT
PCB 02005 Iss 4
BBV
SW3
SW4
ON
1234567
8
ON
1234567
8
ON
1234567
8
SW2
J1
J3
J4
J7
J6
RS422/485
RS232
DEBUG
ON
1234567
8
OUTPUT
PROG INK1
LD1 LD2 LD3
POWER
SW4 output protocol.
For settings see page 9.
SW1 - termination
1/2 DATA In Termination
ON Terminated
3/4 DATA Out Termination
ON Terminated
5 Not used
6/7 MUST BE ON
8 Not used
7812 3 546
ON
LED guide
GREEN LD1 - data IN
YELLOW LD2 - data ERROR
RED LD3 - data OUT
SW3 input protocol
12 3456 78
SW2 address selection.
For settings see page 7.
2 - 3 Parity 4 - 5 Baud Rate 6 - 8 Protocol Selection 
SW3/2 SW3/3
Parity
SW3/4 SW3/5
Baud
SW3/6 SW3/7 SW3/8
Input Protocol
off off off BBV RS422 (TX1500/FBM) (fixed at 9600,N,8,1)
off off NONE off off 2400
off off
ON PELCO P
off ON EVEN off ON 4800
ON off ODD ON off 9600
ON ON NONE
off off NONE off off 2400
off ON off PELCO D
off ON EVEN off ON 4800
ON off ODD ON off 9600
ON ON NONE
off ON ON VCL TP (fixed at 9600,N,8,1)
ON off off 360 VISION (fixed at 9600,N,8,1)

off ON 4800
ON off ON VICON (4800,N,8,1 or 9600,N,8,1)
ON off 9600
ON ON off
MOLYNX “D” TYPE TELEMETRY (fixed at 9600,
E,8,1)
ON ON ON DENNARD (fixed at 9600,N,8,1)
SW3/2 SW3/3  SW3/4 SW3/5 SW3/6 SW3/7 SW3/8
ON ON  ON ON ON ON ON Mark Mercer (fixed at 9600 N,8,1)

SW3/1 – Output camera address
Off Camera address same as input camera address
ON Output camera address always 1
This can assist with some installations where existing domes/receivers are
addressed as 1 therefore the dome/receiver doesn’t need to be reconfigured.
Fig 1 PCB Layout