User's Manual

WIGO800I Instructions
4 / 26
¾ The LCD of your device is designed with precision
technology. However, in some cases, individual pixels may
remain lit or may not light at all. Also, the brightness of the
display may appear inconsistent, depending on the angle
of view. Such anomalies are caused by the nature of the
LCD and do not indicate a malfunction. Please note that
BCM does not guarantee a replacement or refund for such
cases. Do not expose the LCD to direct sunlight for
prolonged periods of time. It may result in a malfunction.
Do not store your device in areas subject to sunlight, such
as near windows, and be careful when using outdoors.
¾ Please take few minutes to run-through this manual,
especially pay attention on [Note], they can be very
useful and important notice for you to use this phone.
Do not skip these notice.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to
operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.