User`s manual

45
4. BIOS Setup
Min Saving Minimum power savings. Inactivity period is 1 hour in each mode
(except the hard drive).
4.7.3 Video Off Method
Determines the manner in which the monitor is blanked.
V/H SYNC+Blank
System turns off vertical and horizontal synchronization ports and
writes blanks to the video buffer.
DPMS Support
Select this option if your monitor supports the Display Power
Management Signaling (DPMS) standard of the Video Electronics
Standards Association (VESA). Use the software supplied for your
video subsystem to select video power management values.
Blank Screen System only writes blanks to the video buffer.
4.7.4 Suspend Type
When enabled and after the set time of system inactivity, all devices except the CPU will be
shut off.
4.7.5 Standby Mode
When enabled and after the set time of system inactivity, the fixed disk drive and the video
would be shut off while all other devices still operate at full speed.
4.7.6 HDD Power Down
When enabled and after the set time of system inactivity, the hard disk drive will be
powered down while all other devices remain active.
4.7.7 HDD Down In Suspend
When enabled and after the set time of system inactivity, the hard disk drive will be in
suspend mode.
4.7.8 Soft-Off by PWR-BTTN
This item allows you to select the function of power button.
The choices: Instant-Off, Delay 4 Sec.
4.7.9 RI Resume/WOL
An input signal on the serial Ring Indicator (RI) line (an incoming call on the modem)
awakens the system from a soft off state. WOL specifies whether the computer responds to