Data Sheet

Bluetooth 5.1 Dual Mode Transceiver Module Based on CC2564C
[e-mail]
BDE Technology Inc.
Datasheet
BDE-BD2564CA
12 / 14
with the modular transmitter installed when contains digital circuity.
7.2. FCC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For 15 B (§15.107
and if applicable §15.109) compliance, the host manufacturer is required to show compliance with 15 while the module
is installed and operating.
Furthermore the module should be transmitting and the evaluation should confirm that the module's intentional
emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply the appropriate equipment
authorization (e.g. Verification) for the new host device per definition in §15.101.
Integrator is reminded to assure that these installation instructions will not be made available to the end-user of the final
host device.
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label stating the FCC ID
of the RF Module, such as "Contains FCC ID: 2ABRU-2564C
"This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation."
"Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment."
The Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the module integrated into the host
device.
7.3. Module statement
The single-modular transmitter is a self-contained, physically delineated, component for which compliance can be
demonstrated independent of the host operating conditions, and which complies with all eight requirements of §
15.212(a)(1) as summarized below.
(1) The radio elements have the radio frequency circuitry shielded.
(2) The module has buffered modulation/data inputs to ensure that the device will complywith Part 15 requirements with
any type of input signal.
(3) The module contains power supply regulation on the module.
(4) The module contains a permanently attached antenna.
(5) The module demonstrates compliance in a stand-alone configuration.
(6) The module is labeled with its permanently affixed FCC ID label.