Data Sheet

[e-mail]
BDE Technology Inc.
BDE-BW2837
Dual-Band Industrial Module –Wi-Fi, BT, and BLE
Datasheet
Datasheet
36 / 39
FCC Part 15.247, Part 15.407
2.3 Specific operational use conditions
This transmitter/module and its antenna(s) must not be co-located or operating in conjunction with any
transmitter. This information also extends to the host manufacturer’s instruction manual.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
It is “not applicable” as trace antenna which is not used on the module.
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
compliance to FCC radiation exposure limits for an uncontrolled environment, and minimum of 20cm separation
between antenna and body.
The host product manufacturer would provide the above information to end users in their end-product manuals.
2.7 Antennas
Chip Antenna; Antenna 1 and 2: 2.2dBi; 2402-2480GHz; 2412-2462MHz;
Chip Antenna; Antenna 1 and 2: 5.2dBi; 5150-5250MHz; 5725-5850MHz
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labeling followed KDB784748D01 and KDB 784748
stating “Contains Transmitter Module FCC ID: 2ABRU-BW2837”.
2.9 Information on test modes and additional testing requirements
For more information on testing, please contact the manufacturer.
2.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) listed on the grant,
and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification. The final host product still requires Part 15
Subpart B compliance testing with the modular transmitter installed when contains digital circuity.
FCC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For 15
B (§15.107 and if applicable §15.109) compliance, the host manufacturer is required to show compliance
with 15 while the module is installed and operating.
Furthermore the module should be transmitting and the evaluation should confirm that the module's
intentional emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply the
appropriate equipment authorization (e.g. Verification) for the new host device per definition in §15.101.
Integrator is reminded to assure that these installation instructions will not be made available to the end-user