Users Manual

BDE-RFM208P-S1
BDE Technology Inc.
PCB Antenna; 2.9dBi; 2402-2480GHz; 2405-2480MHz
915MHz Rob Antenna; 3dBi; 903-927MHz
7. Label and compliance information
The end product must carry a physical label or shall use e-labeling followed KDB784748D01 and KDB 784748
stating “Contains Transmitter Module FCC ID: 2ABRU-RFM208PS1”.
8. Information on test modes and additional testing requirements
For more information on testing, please contact the manufacturer.
9. Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) listed on the grant,
and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host
not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B
compliance testing with the modular transmitter installed when contains digital circuity.
FCC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For
15 B (§15.107 and if applicable §15.109) compliance, the host manufacturer is required to show
compliance with 15 while the module is installed and operating.
Furthermore the module should be transmitting and the evaluation should confirm that the module's
intentional emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply
the appropriate equipment authorization (e.g. Verification) for the new host device per definition in
§15.101.
Integrator is reminded to assure that these installation instructions will not be made available to the
end-user of the final host device.
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label
stating the FCC ID of the RF Module, such as "Contains FCC ID: 2ABRU-RFM208PS1
"This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: