Data Sheet

[e-mail]
BDE Technology Inc.
BDE-WF3235
BDE Dual-Band WiFi MCU Module
Datasheet
Datasheet
75 / 77
10.3 Module statement
The single-modular transmitter is a self-contained, physically delineated, component for which compliance can be
demonstrated independent of the host operating conditions, and which complies with all eight requirements of §
15.212(a)(1) as summarized below.
(1) The radio elements have the radio frequency circuitry shielded.
(2) The module has buffered modulation/data inputs to ensure that the device will complywith Part 15 requirements
with any type of input signal.
(3) The module contains power supply regulation on the module.
(4) The module contains a permanently attached antenna.
(5) The module demonstrates compliance in a stand-alone configuration.
(6) The module is labeled with its permanently affixed FCC ID label.
(7) The module complies with all specific rules applicable to the transmitter, including all the conditions provided in
the integration instructions by the grantee.
(8) The module complies with RF exposure requirements.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
10.4 IC Statements
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary label stating the IC of
the RF Module, such as" Contains transmitter module IC: 25657-WF3235
Le périphériquehôte final, danslequelce module RF estintégré "doitêtreétiqueté avec uneétiquetteauxiliaireindiquant
le CI du module RF, tel que" Contient le module émetteur IC: 25657-WF3235
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licencecontenudans le présentappareilestconforme aux CNR d’Innovation, Sciences
et Développementéconomique Canada applicables aux appareils radio exempts de licence. L’exploitationestautorisée
aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;