Installation & Assembly

Product Registration

Registering your new BDI product allows us to send you important

product updates, service information and helpful hints related to

your BDI products. Register today, and you will be entered to win

free a BINK table from BDI: www.bdiusa.com/register

Placement and Maintenance

Your MILO Media Table is designed for indoor use on level floors.

Clean wood veneer, aluminum and steel parts with a moist cloth.

Milo is engineered for easy assembly. Carefully follow this

procedure to prevent any damage. Do not use power tools for

assembly of this product.

Step 1

Unpack and identify the parts listed below. The assembly

workspace should be a non-marring surface such as carpet.

For missing hardware pieces, contact BDI Customer Service at:

customerservice@bdiusa.com.

For all other concerns, please contact your BDI retailer.

These distinctive product conﬁgurations are protected by US and international patents, trade dress, and/or

Patent: www.bdiusa.com/ip

Made in China. 02.11.2020 V2

T1 Hex Wrench x 1

A1 Mounting Plate x 1

A2 Post x 1

H1 Threaded Rods x 2

H1 Flathead Screws x 4

A3 Base x 1

C1 Top Panel x 1

Tool Included:

bdiusa.com

customerservice@bdiusa.com

MILO

1055/1065

MEDIA TABLE

PAGE 1
MILOTM 1055/1065 MEDIA TABLE bdiusa.com customerservice@bdiusa.com Product Registration Registering your new BDI product allows us to send you important product updates, service information and helpful hints related to your BDI products. Register today, and you will be entered to win free a BINK table from BDI: www.bdiusa.com/register Placement and Maintenance Your MILO Media Table is designed for indoor use on level floors. Clean wood veneer, aluminum and steel parts with a moist cloth.
PAGE 2
Step 2 - Attach Mounting Plate to Top Panel Place top panel C1 upside down on a non-marring surface. Position mounting plate A1 over the 4 threaded holes with the stem towards the outside and attach with 4 flathead screws H1 using hex wrench T1. T1 H1 Overhead View Stem towards edge Threaded holes A1 C1 2 MILO 1055 MEDIA TABLE bdiusa.com customerservice@bdiusa.
PAGE 3
Step 3 - Attach Post and Base Slide either end of the post 2A onto the stem of mounting plate A1. Place the stem of base A3 into the opposite end of the post A2 and secure in place with 1 hand. With your other hand, slide 2 threaded rods H2 into the channels that run through post A2 and into the holes on the mounting plate A1. Tighten with hex wrench T1. T1 H2 x 2 A3 A2 Stem A1 3 MILO 1055 MEDIA TABLE bdiusa.com customerservice@bdiusa.