Assembly Instructions

4
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Step 7
Optional fabric speaker or glass insert panel
Avion’s drawer and door fronts feature removable/
replaceable panel inserts to permit customization of your
cabinet’s appearance and utility. (Contact BDI Customer
Service at [e-mail])
Installing optional panel inserts is quick and easy:
1. From the inside of the door, and starting at one
corner of the pre-installed Glass or Speaker panel insert,
carefully pull away all four sections of the panel retention
trim, running along the perimeter of the insert. (Use a
blunt, tapered object or your finger to start removing the
rubber material.)
2. Once the trim material is completely pulled away,
remove the pre-installed panel insert and replace it with
the desired panel insert.
3. Re-install the trim, pressing it carefully back into the
groove around the new panel insert, section by section, to
complete the panel insert installation.
Step 8
Center channel speaker option
If you decide to use your top/center drawer area for
a center channel speaker, the drawer may be easily
removed. In order to do this, follow the steps below.
Step 9
Option: Removing Center Drawer Divider
Remove Center Drawer Divider by loosening & removing
Philips head screw fasteners, installed on outer-side walls
of Drawer Assembly, using provided Philips Screwdriver
(A). Divider can be re-installed within the Drawer by
positioning at one of the pre-determined locations and
threading Philips screws through corresponding holes in
outer-side walls and into Divider with screwdriver.
a. Remove rubber trim and
glass panel.
b. Replace insert panel
Fully extend drawer and locate
plastic lever on drawer slide.
Simultaneously on the LEFT side of drawer, lift UP on plastic lever
AND on the RIGHT side of drawer, push DOWN on plastic lever and pull
STRAIGHT OUT the entire drawer assembly. Remove drawer slides from
interior side panels using a Phillips screwdriver.