Instructions

bdiusa.com
[e-mail]
MÜV 1252
Table
3
Step 4 - Place hex driver T1 into the access holes at a 45 degree angle and tighten the connectors by turning
clockwise about 1/4 turn until tight. You may need to wiggle the hex driver until the end of the driver engag-
es with the connecting hardware. Tighten all 4 connectors.
Step 5 - Orient the bottom panel C3 as shown and slide it so that the aluminum channel goes into the slot on
bottom panel C3. Keep sliding until the mitered edges align and touch. Wiggle and lift bottom panel C3 to
align the joint and close the seam.
4 access holes
to tighten connectors
C2 Middle Panel
T1 Hex Driver
C3 Bottom Panel
Aluminum Channel