Component Assembly Guide

PB
4
6:
Insert the Glass (S) at an angle and fit
glass pucks into designated holes on
Frame.
8:
Remove Adhesive Foam/Magnets from
the Upper Beam. Peel film from side of
the Adhesive Foam/Magnets and attach
to clean, dry back side of AC power strip
(not included). Cleaning of power strip
surface with rubbing alcohol will ensure
best adhesive bond. **UNPLUG POWER
STRIP FROM POWER SOURCE BEFORE
CLEANING**Attach AC power strip/surge
protector to inside of Upper Beam.
9:
Use the slot holes provided to run all
wires to and from the desk. Keep all
wires behind folded metal lip—failure
to do so will prevent Kick Panel (P)
from attaching properly. Once all of the
electrical wires are routed, install Kick
Panel (P) as shown below. The rear side
of panel has magnets that will hold the
panel in place. Note: The Inline Desk is
designed to permit placement in front
of an electrical outlet for easier wiring
access.
7:
S
* AC Power Strip Not Included
2.
3.
1.
FRONT
BACK
O
P