Specifications

. . . . .
USING THE CONTROL BUTTONS
RGB-DVI Converter Adjustment Modes
DVI Converters - Installation & Operation Guide Edition 1.01 Operation 13
blinking pattern (about 3 seconds). At this point, the up and down buttons would set the
modulus up and down.
To Exit an Adjustment Mode
• To exit any of the adjustment modes, hold down the Menu button until the normal
operation mode LED blink pattern returns (about 3 seconds).
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RGB-DVI CONVERTER ADJUSTMENT MODES
There are six adjustment modes for the RGB-DVI Externally-Powered Converter.
MODULUS
Use this adjustment mode to modify the modulus applied to the RGB input signal.
PHASE
Use this adjustment mode to modify the phase applied to the RGB input signal.
TEST PATTERN
The RGB converter unit can generate nine different test patterns. In Test Pattern mode, you
can select the output test pattern to be generated. The default output resolution is 640 x 480.
Additional output resolutions are available via serial command. (See the
inputtestpattern command in Appendix A, “RS-232 Protocol.”)
HORIZONTAL POSITION
In this mode, you can adjust the horizontal position of the RGB input relative to the output.
VERTICAL POSITION
In this mode, you can adjust the vertical position of the RGB input relative to the output.
TEST PATTERN ROTATE
In this mode, each of the nine test patterns are displayed at a resolution of 640 x 480. Each
test pattern remains on the output for approximately five seconds.
NOTE:
The changes that these adjustment modes make to the device can be seen
immediately, but the changes are not be stored to non-volatile memory
until you exit the adjustment mode and return to the normal operation
mode. If the unit is powered off before the normal mode is re-entered, the
changes made in the last adjustment mode are lost.