Product Manual

INSTRUCTIONS
Wet Sandblaster Kit
For suction fed injection of sand into the water stream for abrasive cleaning. Gun, wand, and sand not included.
This manual contains important
warnings and information.
READ & KEEP FOR REFERENCE.
WARNING
EXHAUST HAZARD
The engine exhaust contains poisonous carbon monoxide which is colorless and odorless.
Do not operate combustion engines in a closed building.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury
• Do not alter or modify this equipment
• Check equipment daily. Repair or replace worn or damaged parts immediately.
• Do not exceed the maximum working pressure of the lowest-rated system component.
• Do not disassemble or modify system while in use.
• Consult the operators manuals for the pressure washer and engine prior to use.
INJECTION HAZARD
• Fluid injected into the skin is a serious injury. The injury might look like just a cut but it’s as serious injury. Get
immediate medical attention.
• Do not put your hand or fingers over the spray tip.
• Do not stop or deflect leaks with your hand, body, glove or rag.
• Tighten all connections before you operate this equipment
!
5,500 psi (379 bar) Maximum Working Pressure
10.0 GPM (37.8 LPM) Maximum Flow
BEFORE YOU BEGIN
WARNING
To reduce the risk of injury, always protect eyes
and face with goggles and mask and hands and
arms with heavy work gloves, when spraying
abrasive materials. Also use protective clothing
and boots.
Always point the sandblaster nozzle downward when not spraying.
This prevents water from entering the sand supply.
Always be sure the sand hose is dry before using.
Keep the sand covered to prevent the overspray from wetting the
sand.
Do not allow small pieces of the sand bag to fall into the sand
supply. A small piece of paper could prevent the flow of sand.