AC558RB AC7011RB operation manual
table of contents Introduction 4 Using the Operators Manual Specifications 4 Specifications Product Identification 5 Record Identification Numbers Safety 6 Safety Instructions 7 Safety Rules 7 Hazard Symbols and Meanings 10 General Safety Information Safety & Installation 11 Spraying Precautions 11 Hose Precautions 11 Installation and Location 11 Extension Cords Assembly Instructions 12 Assembly Product Features 13 Automatic ON/OFF 13 Regulator 13 Tank Pressure Gauge 13 Safety Val
table of contents 14 Initial Start Up 14 Start Up 14 Storage 14 Shut Down Maintenance 15 When performing any maintenance or service 15 Daily 15 Weekly 14 Monthly 15 Six Months or 250 Operating Hours 15 Oil Change Troubleshooting 16 Troubleshooting Chart Parts 17 Parts Diagram 18 Parts List 3
introduction Attention: Read through the complete manual prior to the initial use of your compressor. Using the Operator’s manual Thank you for choosing our compressor. The manual gives information with respect to operation and maintenance of the Compressor and be sure to read it carefully first before operation. Following the manual can ensure the user’s safety and get the best results from the compressor.
product identification Record Identification Numbers Compressor If you need to contact an Authorized Dealer or Customer Service line (1-866-850-6662) for information on servicing, always provide the product model and identification numbers. You will need to locate the model and serial number for the machine and record the information in the places provided below.
safety Safety Instructions · Carefully read through the entire owners manual before operating this compressor. · Keep manual with important records for safety instructions, operating procedures and warranty. · After unpacking your new air compressor, please inspect it carefully for any damage that may have occurred during transit. · Do not operate this air compressor if damaged during shipment, handling or misuse. · Damage may result in bursting, which can cause serious injury or property damage.
safety Save these Instructions Safety Rules This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. The safety alert symbol ( ) is used with a signal word (DANGER, CAUTION, WARNING), a pictorial and/or a safety message to alert you to hazards. DANGER indicates a hazard which, if not avoided, will result in death or serious injury.
safety warning AIR TANK WARNING: Drain liquid from air tank daily, or after each use, using the drain valve located on the bottom of the lower air tank. Failure to properly drain liquid from the tank will cause rust from moisture buildup, which weakens the tank and could lead to a violent tank explosion, Periodically inspect the tanks for unsafe conditions such as corrosion. Never attempt to repair or make modifications to the tank or its attachments.
safety warning AIR TOOLS AND ACCESSORIES WARNING: Do not exceed the pressure rating of any air tools, spray guns, air accessories, or inflatables. Excess pressure can cause them to explode, resulting in serious injury. Follow the manufacturers recommended pressure settings for all air tools and air accessories. warning Do not direct compressed air stream at people or pets. The powerful compressed air stream can damage exposed skin and easily propel loose dirt and other small objects.
safety General Safety Information Do not operate unit if damaged during shipping, handling or use. Damage may result in bursting and cause injury or property damage. Since the air compressor and other components (filters, lubricators, hoses, etc.) used, make up a high pressure pumping system, the following safety precautions must be observed at all times: 1. Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper use of the equipment. 2.
safety & installation Spraying Precautions 15. Do not smoke when spraying paint, insecticides, or other flammable substances. 16. Use a face mask/respirator when spraying and spray in a well ventilated area to prevent health and fire hazards. 17. Do not direct paint or other sprayed material at the compressor. Locate compressor as far away from the spraying area as possible to minimize overspray accumulation on the compressor. 18.
assembly instructions Assembly Read all safety instructions before using air compressor. warning The compressor is shipped without oil in the crankcase. Add oil as indicated below. Check Oil Level Daily Oil Level OK Refill Oil Immediately 1. After opening the carton, please remove all parts and check against photograph on carton. If any parts are missing, please call 1-866-850-6662. 2. Place air compressor on a flat, level surface. 3.
product features Product Features 1. Automatic ON/OFF Pressure Switch The compressor is equipped with an automatic on/off pressure switch. The compressor will only run when the switch is in the “I”(ON) position. Once the tank has reached the desired preset pressure (see Operation Instructions), the pump will automatically shut off. While the switch is in the “I”(ON) position, the pump will automatically turn back on once the pressure in the tank drops below the minimum preset pressure.
operation Operating Instructions Initial Start Up 1. Disconnect tools and/or accessories from the air hose. 2. Open the tank drain valve to allow air to escape preventing air pressure buildup in the air tank. 3. Check to see that the belt is installed properly with the correct tension. 4. Plug power supply cord into proper power source receptacle. (See Grounding Instructions) 5. Run the compressor for a minimum or twenty minutes in this no-load position to lubricate the bearings and piston. 6.
maintenance Maintenance When performing any maintenance or service ·· The air compressor must be turned off. ·· Drain tanks. ·· Allow compressor to cool down. Daily ·· Check oil level. ·· Drain accumulated liquid from tanks. ·· Check for oil leaks. ·· Check for unusual noise and/or vibrations ·· Check that all fasteners are secure. Weekly ·· Check safety relief valve. ·· Inspect and clean air filter. ·· Clean breather holes on oil check dipstick. Monthly ·· Check for air leaks.
troubleshooting Troubleshooting Chart Trouble Possible Cause Corrective Action No start condition Gas engine not running Check operation of gas engine Low pressure Air leak in safety valve Check valve manually by pulling upward on rings. If condition persists, replace valve.
parts Parts Diagram Parts List No. Description Qty Part # No. Description Qty Part # 1 21 Angle Nut 2 0.37M 22 Tank Wheel 1 Exhaust Pipe 1 23 Air Tank 1 Nut 2 24 Wire 1 42.004.007 2 Safety Guard 1 25 Gas throttle line 1 42.004.007 3 M5x0.8x8 Screw 3 26 Gas throttle 1 42.004.007 4 Bolt 2 27 Air Connector 1 42.004.008 5 Spring Washer 2 28 Exhaust Elbow 1 42.004.
parts Parts List No. Description Qty Part # No. Description Qty Part # 1 In-Six Angle Bolt 8 28 Exhaust Elbow 1 2 Spring Washer 8 29 Copper Pipe Assy, Exhaust 1 30 Cooler 1 3 Cylinder Head 2 4 Air Filter Assembly 2 42.004.006 31 Exhaust Pipe 1 5 Six Angle Bolt 4 42.004.006 32 Exhaust Nut 2 Bolt 4 6 Washer 4 42.004.006 33 7 Gasket, Cylinder Head 2 42.004.001 34 Spring Washer 4 8 Valve Seat 4 35 Bearing Cover 1 9 AI, Gasket 2 42.004.
If you need assistance with the assembly or operation of this Compressor please call 1-866-850-6662
