User's Manual

Page 2 of 4 75.5868.01 900 MHZ TOUCHLESS RETROFIT TRANSMITTER 20160412
• The device should not be used for purposes other than its intended use. All other uses cannot be
guaranteed by the manufacturer of the sensor.
• The installer of the door system is responsible for carrying out a risk assessment and installing the sensor and
the door system in compliance with applicable national and international regulations and standards on door
safety.
• The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate
adjustments of the sensor.
1 2 3
Remove existing touch
pushplate and disconnect two
(2) existing in-wall wires from
pushplate and door control
activation.
Connect green and white
wires to new touchless plate
activation output.
Parallel red and black wires
with two (2) existing in-wall
wires and connect to new
touchless plate power input.
INSTALLATION
4 5 6
Mount new touchless plate. Connect two (2) existing in-
wall wires to power source in
door control header.
Install 900 MHz wireless
receiver in header (sold
separately).