Technical data

Configuring and Managing JDBC Connection Pools, MultiPools, and DataSources Us-
Administration Guide 16-31
JDBC Management Using the Command-Line Interface
The following table describes the Connection Pool management using the
command-line interface. Select the command for more information.
For information on using the Connection Pool commands, see Appendix B,
“WebLogic Server Command-Line Interface Reference.”.
Monitor a Connection Pool 1. Select the pool in the left pane.
2. Select the Monitoring tab in the right pane, then select
the Monitor All Active Pools link.
Modify an Attribute for a
Connection Pool, MultiPool,
or DataSource
1. Select the JDBC object—Connection Pool, MultiPool,
or DataSource—in the left pane.
2. Select the Target tab in the right pane, and unassign the
object from each server (move the object from the
Chosen column to the Available column.) Then click
Apply. This stops the JDBC object—Connection Pool,
MultiPool, or DataSource—on the corresponding
server(s).
3. Select the tab you want to modify and change the
attribute.
4. Select the Target tab and reassign the object to the
server(s).This starts the JDBC object—Connection
Pool, MultiPool, or DataSource—on the
corresponding server(s).
Table 16-21 JDBC Management Tasks
If you want to . . . Do this . . . in the Administration Console
Table 16-22 Managing Connection Pools with the Command-Line Interface
If you want to . . . Then use this command . . .
Disable a Connection Pool
DISABLE_POOL
Enable a Connection Pool
that has been disabled
ENABLE_POOL
Delete a Connection Pool
DESTROY_POOL