Technical data

Tuning JMS
Administration Guide 17-23
3. Click the template that you want to configure for paging. The right pane shows
the tabs associated with configuring the template.
4. On the Thresholds & Quotas tab, configure bytes paging:
l Select the Bytes Paging Enabled check box.
l In the Bytes Threshold High field, enter an amount that will start bytes
paging when the number of bytes on the JMS server exceeds this threshold.
l In the Bytes Threshold Low field, enter an amount that will stop bytes
paging once the number of bytes on the JMS server falls below this
threshold.
5. On the Thresholds & Quotas tab, configure messages paging:
l Select the Messages Paging Enabled check box.
l In the Messages Threshold High field, enter an amount that will start
messages paging when the number of messages on the JMS server exceeds
this threshold.
l In the Messages Threshold Low field, enter an amount that will stop
messages paging once the number of messages on the JMS server falls below
this threshold.
6. Click Apply to save the new bytes and/or messages paging values.
7. Repeat steps 3–5 to configure paging for additional JMS templates.
8. After configuring all of your JMS templates for paging, reboot WebLogic Server
to activate paging.
Configuring Paging on Destinations
Follow these directions if you are configuring paging on destinations without using a
JMS template.
1. Under JMS Servers, click to expand a server instance that is already configured for
paging.
2. Click the Destinations node. The right pane shows all of the server's topics and
queues.
3. Click the topic or queue that you want to configure for paging. The right pane
shows the tabs associated with configuring the topic or queue.