Operating instructions

15
STANDBY MODE
Pressing followed by or will turn off all hot tub
functions temporarily. SBY will appear on your display. This
is helpful when changing a filter element. Pressing any button
exits Standby mode. Note: If the hot tub is in a heat cycle when
standby is selected the 2 speed filter pump or HushPump™ will
run for approximately 15 seconds.
FILTER CYCLES
The first filter cycle (“day”) begins 6 minutes after the hot tub is
powered up. The second filter cycle (“night”) begins 12 hours
later. If the hot tub is not HushPump™ equipped filter duration is
programmable for 1-12 hours (F1-F12). The default filter time is
2 hour cycles twice a day.
To Program:
1. Press button then
2. Press
to select the filter duration.
3. Press
to select the number of filter cycles.
4. Display will show
DN (both day and night cycles);
or D (day cycle only); or N (night cycles only). Press
to adjust
5. Press
to exit programming mode.
6. HushPump™ equipped hot tubs will automatically
filter 2-12 hour cycles per day. No programming
is available on Hush equipped hot tubs due to the
energy efficiency of the HushPump™.
Changing filter cycles on HushPump™ equipped tubs will only
affect the times the heater comes on if using the Economy
Heating mode. It does not the change the amount the
HushPump™ runs.
PERIODIC REMINDER MESSAGES
(press the button to reset a displayed reminder message)
rPH: Test and adjust pH chemical levels as per Beachcomber
instructions. Reminder is every 7 days.
rCL: Remove, clean, and reinstall Microfilter Cartridge as per
Beachcomber instructions. Reminder is every 30 days.
rt9: Test & reset GFCI as per Beachcomber instructions.
Reminder is every 30 days.
rdr: Drain and refill hot tub as per Beachcomber instructions.
Reminder is every 90 days.
rCO: Clean and condition Heatshield as per Beachcomber
instructions. Reminder is every 180 days.
rCH: Install new Microfilter cartridge. Reminder is every
365 days.
To suppress reminders, refer to the edit menu on page
16 of this Owner’s Guide.
DIAGNOSTIC DISPLAY MESSAGES
OHH or OHS: Overheat-DO NOT ENTER HOT TUB
ICE: Potential Freeze
SNA: Hot tub is shut down
SNB: Hot tub is shut down
SNS: Sensor out of balance
HFL: Could indicate flow problem
LF: Persistent low flow problems
DR: Inadequate water detected
DRY: Inadequate water detected
PR: Hot tub in priming mode
- - : Temperature unknown
STD: Hot tub is in Standard mode
ECN: Hot tub is in Economy mode
SE: Hot tub is in Standard-Economy mode
PLEASE REFER TO TROUBLE SHOOTING GUIDE
ON PAGE 23 FOR A COMPLETE EXPLANATION OF
DIAGNOSTIC MESSAGES.
ALWAYS TEST WATER TEMPERATURE
PRIOR TO ENTRY USING THE TOPSIDE
CONTROL PAD. ENSURE COMFORT BY ALSO CHECKING
WATER WITH A THERMOMETER.
WARNING
SHOCK HAZARD!
NO USER SERVICEABLE PARTS.
DO NOT ATTEMPT SERVICE OF THIS CONTROL.
CONTACT YOUR DEALERSHIP OR SERVICE PROVIDER
FOR ASSISTANCE. FOLLOW ALL OWNER’S GUIDE POWER
CONNECTION INSTRUCTIONS. INSTALLATION MUST
BE PERFORMED BY A LICENSED ELECTRICIAN AND
ALL GROUNDING CONNECTIONS MUST BE PROPERLY
INSTALLED. TAMPERING WITH OR MODIFYING THIS
EQUIPMENT MAY VOID YOUR GUARANTEE.
WARNING
TAMPERING WITH OR MODIFYING
THIS EQUIPMENT MAY VOID YOUR
GUARANTEE.
WARNING