Operating instructions

19
PLASTIC COMPONENTS
The jets should be removed periodically and
rinsed out to remove debris from the spinning
assemblies. If calcium build-up is present, soak
the parts in Filter Cure to loosen the calcium
and then scrub with a brush and rinse off. If
a lot of hair and debris is present on suction
covers located in the foot well, this can reduce
water flow to the pumps. Manually remove
when the hot tub is empty or full.
Operation of Hot Tub Interior Features
MASSAGE INSERTS OR JETS
The jets in a Beachcomber Hot Tub are known
as Energ-Jets™ in three sizes; small, medium
and large. They are interchangeable within
the same sizes. See Figure 9 Simply turn them
counterclockwise until they click and pop
out. To re-install, line up the small protrusion
on the back of the face plate with the slot on
the white WaterPort and then turn clockwise
and push in until they click in. The jets can
also be individually turned off/on. Simply
turn clockwise to turn off the water flow and
counterclockwise to turn on water flow.
To turn on the neck jet on the model 350 or 500
and 700 series hot tubs turn counterclockwise
to turn on and clockwise to turn off. If this jet
does not turn off then carefully pry the face
plate off with a flat head screw driver, and screw
the internal portion back in by hand. Then pop
the face plate back on and turn it clockwise to
tighten in the internal portion.
AIR CONTROL VALVES
There are two air control valves located on
either side of the touch pad. See Figure 10. In
the six o’clock position they are off, meaning
no air can be drawn to the jets. To allow air
to be drawn in, turn the lever to the 2 o’clock
position. On 300, and 500 series hot tubs the
left air control services the seat jets on the left
of the hot tub and jets in the foot well. The
right air control services seat jets on the right
side of the hot tub. These air controls improve
the massage experience in your hot tub by
adding more turbulence to the water flow.
On the 350 model and 500 series hot tubs with the
Reflex Foot Massage (RFM) option, the right air
control services the RFM jets when the water flow
is diverted to them and the left air control services
all the seat jets. On the 700 series, the left air
control allows air flow to jets running off Massage
Pump 1. The right air control allows air flow to jets
running off Massage Pump 2. The right air control
would also allow air flow to the RFM jets if the
diverter valve is diverting water flow from Massage
Pump 2 to the RFM jets. On all models more air is
drawn in when the jet pump is on high speed than
when the pump is on low speed.
RFM DIVERTER VALVE
The purpose of this valve is to divert water flow
between either the RFM foot jets or the seat jets.
See figure 11 . On 700 series hot tubs it diverts water
flow from massage 2 pump between the RFM foot
jets or the seat jets on the left side of the hot tub.
Always turn the pump to low speed or off before
attempting to turn the RFM Diverter Valve. Failure
to do this could cause the handle to break due
to the high velocity of water moving through the
valve. Note: when the hot tub is not being used,
NEVER USE AN ABRASIVE CLEANER
FOR CLEANING THE ENVIROSKIRT™
CABINET AS THIS WILL DAMAGE THE FINISH.
WARNING
figure 9
figure 10
PROTRUSION
GROOVE