Specifications

3 - 1 How to Use and Maintain your Hot Tub
STARTING YOUR
BEACHCOMBER HOT TUB
After your hot tub is installed by a
qualified installer, your Beachcomber
dealer will come and start up your hot tub
for you. But before they arrive at your
home to do the “wet start” with you, you
can fill your hot tub - it does not require
special water - it is designed to be filled
with water directly from your garden hose.
Note: Do not use your hot tub until a
disinfectant level has been established.
When you first fill your hot tub, and
depending on where you live and the type
of water supply you have, the water may
appear somewhat green once the hot tub
is filled. This is normal! Beachcomber’s
water treatment program will soon give
you clear, sparkling water to enjoy with
family and friends! The steps that follow
are outlined for you to show you how your
dealer will first start your hot tub. It’s best
to allow your dealer to do this for the
first time to show you the simple steps
of start up.
WARNING
Always make sure that there is enough
water in your hot tub. Low water levels
can damage your equipment and void your
guarantee.
STEP 1: PREPARING THE EQUIPMENT
Switch the power at the main power
supply panel to the “Off” position. Open all
knife valves to allow the water to fill the
equipment for proper water flow. Make
sure that the drain fitting is closed. Make
sure the filters are in place in the
microfilter / upfront system (See
illustration on page 3 - 3).
STEP 2: FILLING THE HOT TUB
Fill the hot tub with water from your
garden hose, to the correct level.
SPECIAL NOTE:
There may be air inside the equipment that
needs to be bled to prevent damage to the
internal equipment. To bleed the air, open
the black air bleed valve one half turn to
release any trapped air.
Correct water level for
Beachcomber’s Microfilter:
halfway up the skimmer opening