Specifications

5 - 7 Programmable Control Instructions/Digital 2000
Start Up
When your hot tub is powered up, it will
automatically heat and maintain 100
o
F/37.5
o
C or
your desired temperature.
Temperature Adjustment (80 ˚F-
104˚F)/(26˚C-40˚C)
Press the pad to display the temperature
previously set. This set temperature is flashed on
the display. In a few seconds, the numbers will stop
flashing, and the display will show the actual
temperature. Pressing the pad a second time will
cause the set temperature to increase or decrease
depending on what direction was last chosen. Each
press to follow will change the set temperature in
the same direction. If the opposite direction is
desired, release the pad and let the display revert to
the actual water temperature. Press the pad to
display the set temperature, and again to make the
temperature change in the desired direction.
Massage
Press the pad to activate the pump’s low
speed, again for the pump’s high speed, and once
more to turn off the pump. The pump’s low speed
turns off after 2 hours. The pump’s high speed turns
off after 15 minutes of use.
Light
Press the pad the turn the hot tub light on
and off. The light will automatically turn off after 4
hours of use.
Standby Mode
Press then withnin 3 seconds to
prevent the hot tub from operating at any time.
Standby mode should be used when replacing the
filter. All hot tub functions will be disabled excpet for
freeze control. Press any button to resume hot tub
operation.
Preset Filter Cycle
Due to the energy efficiency of the hugh pumptm
option, your hot tub is set to automatically filter
itself 24 hours a day, although there are other filter
duration’s, it is not recommended to change this
setting. Filter duration is programmable at the top-
side panel. Press the pad, then the pad
within 3 seconds and “F2” will be displayed on the
panel. (“F2” is the default filter time and indicates a
2 hour cycle.) Continue pressing the pad to
cycle through the rest of the filter time options; “F4”
- 4 hours, “F6” - 6 hours, “F8” - 8 hours, “F0” - 10
hours, and “FC” - 24 hours. Press to select
the number of cycles. Display will show “C1” or
“C2”. During filtration the ozone generator (if
installed) will run.
DIGITAL 2000 MANAGEMENT SYSTEM
TWO SPEED PUMP VERSION