Specifications

5 - 9 Programmable Control Instructions/Digital 1000
START UP
When your hot tub is first powered up, it will
automatically heat and maintain 100˚ F / 35˚ C
until you change the set temperature.
TEMPERATURE ADJUSTMENT
Press the pad to display the temperature
previously set. This set temperature is flashed
on the display. In a few seconds, the numbers
will stop flashing and the display will show the
actual water temperature (minimum
temperature +80
O
F - maximum temperature
+104
O
F). Pressing the pad a second time will
cause the set temperature to increase or
decrease depending on what direction was last
chosen. Each successive press will change the
set temperature in the same direction. If the
opposite direction is desired, release the pad
and let the display revert to the actual water
temperature again. Press the pad to display the
set temperature, and again to make the
temperature change in the desired direction.
LIGHTS/JETS
Press the pad to cycle through
the light and jets features. The operating
sequence is as follows: 1) low-speed pump, 2)
low-speed pump and light, 3) high-speed
pump and light, 4) high-speed pump only, and
5) off. The low-speed pump automatically turns
off after 2 hours. The high-speed pump stops
after 15 minutes. The light turns off after 4
hours of use.
PRESET FILTER CYCLES
Your hot tub will automatically filter itself twice
a day. The first filter cycle will start one minute
after the hot tub is powered up. The second
filter cycle will begin twelve hours later. Filter
cycle duration is 2 or 6 hours long, and is set
at the time of delivery. The low-speed pump
and ozone generator (if installed) will run
during filter cycles. Contact your local dealer to
change the cycle.
DIGITAL 1000 ENERGY SAVER