Specifications

Programmable Control Instructions/Digital 1000 5 - 12
STANDBY MODE
The hot tub can be disabled when the filter
needs to be replaced. Press the “Set” pad then
the “Lights/Jets” pad and the display will show
“Sb”. All hot tub functions will be disabled
except for freeze control. Press any panel
button to resume hot tub operation.
DISPLAY MESSAGES
DISPLAY FLASHES “OH”.
“Overheat” (hot tub is deactivated). The hot tub
has shut down. Either the water has reached
112
o
, or the high limit sensor has detected 118
o
at the heater. DO NOT ENTER THE WATER.
Remove the hot tub cover and allow the water
to cool. At 110
o
, the hot tub should
automatically reset. If the hot tub does not
reset, then shut off power to the hot tub and
call your dealer.
DISPLAY FLASHES “FL”.
“Flow”. The pressure switch is not working.
Call your dealer.
DISPLAY FLASHES “Sn”.
“Sensor” (hot tub is deactivated). The high-
limit sensor or water temperature sensor is not
working. Call your dealer.
DISPLAY FLASHES “Sb”.
“Standby” mode (hot tub is deactivated). All
hot tub functions are disabled except for freeze
control. Press any panel button to resume hot
tub operation.
WARNING! SHOCK HAZARD! NO USER
SERVICEABLE PARTS.
Do not attempt service of this control. Contact
your dealer or service organization for
assistance. Follow all owner's manual power
connection instructions. Installation must be
performed by a certified electrician and all
grounding connections must be properly
installed.