Specifications

7 - 3 Questions and Answers about your Beachcomber Hot Tub
How often do we clean our filters?
This can depend on usage. If you have lots
of friends that are enjoying the hot tub
with you, you will need to clean them
more often. Inspect your filters to check
for leaves and other debris that may
impair their ability to filter the water. We
recommend that you clean them once a
month with Filter Pure or Filter Cure. You
should have two sets; rotating them so
that one is always ready and clean. A filter
cleaning canister is a time saver and is
also available from your Beachcomber
Store.
How do we replace our light?
SPECIAL NOTE:
This is best left to your Beachcomber
Dealer to do for you. If you want to do it
yourself, bear in mind that you could
damage your hot tub, and you may void
your Guarantee.
Use Beachcomber’s light removal
tool to remove the light lens.
Turn off all power at the main power
source to your hot tub. Drain the hot tub
(see page 3-2 for directions). With the
supplied “light removal tool” unscrew the
center of the light lens by turning
counterclockwise. Remove the old bulb
and install a new one. Replacement bulbs
are available from your local Beachcomber
dealer. To replace the lens, screw it in
clockwise with the tool and hand tighten
until it is snug. Do not overtighten, or you
may risk cracking the lens.
Our hot tub’s mechanical controls don’t
seem to be working.
Your manual button switch is removeable.
You can do that by rotating the outer ring
clockwise 1/8 of a turn and popping it off.
Inside the switch mechanism is a black
bellows called a “diaphragm” that may be
damaged or cracked. Simply take it out
and get a new diaphragm from your
Beachcomber store.
Beachcomber’s mechanical
air buttons.
LIGHT