Operating instructions

USER EDIT MENU
This feature is only available on 700 Series tubs that have the
Energy Saver Management System remote installed.
There are three selections in the User Edit Menu:
Suppress Reminders: This SST2 system will display a
number of reminders prompting you to perform certain
maintenance tasks. If you do not want these reminders to
be displayed you can suppress them.
Temperature Display: You can change your temperature
read out from Fahrenheit to Celsius.
Time Display: You can change the time clock display from
12 hour am/pm to 24 hour Military.
ACCESSING THE USER EDIT MENU
Press the then 1, then , USr will be
displayed. Then press 1 to display Sr.n (Suppress
reminders). To suppress press 1 again to make the n
flash. Press to change the n to a Y and then press
1 to confirm, then button twice to exit. Reminders will now
be removed.
If you want to change the temp display from Fahrenheit to
Celsius use the same procedure as above to get to Sr.n but
then press to go to tc.n then 1 to make the n
flash, to change the n to Y and then 1 to confirm.
If you want to change the time display from am/pm to 24 use
the same procedures as above to get to Sr.n and then press
twice to get to 24.n then press 1 to get the n to
flash, press to change the n to Y and then 1 to
confirm then twice to exit.
1.
2.
3.
12
TOPSIDE CONTROL PANEL STANDBY FEATURE
The Standby feature is used primarily to temporarily shut the circulation pump off
before removing the Micro Filter for cleaning or replacement. This prevents debris
or objects from entering the circulation pump while the skimmer basket and filter
are out. Standby can also be used if the user wants to have total quiet while
using the hot tub but during this time the tub will not heat.
Do not use Standby to drain and refill your hot tub.
Use the instructions below to put your hot tub into Standby.
LightWarm
Cool Massage1 2
Time
Mode/Pro g
LightWarm
Cool Massage1 2
Time
Mode/Pro g
LightWarm
Cool Massage1 2
Time
Mode/Pro g
ET-70 TOPSIDE CONTROL PANEL ON 700 SERIES TUBS
Press then to put the tub into Standby. Press any button to take the
hot tub out of standby.
Ligh tLigh tLigh t TempTempTemp
Mass ageMassageMassage
HeatHeatHeat
ET- 50 TOPSIDE CONTROL PANEL ON 500 SERIES TUBS
MassageMassageMassage TempTempTemp
LightLightLight
ET- 30 TOPSIDE CONTROL PANEL ON 300 AND 160 SERIES TUBS
For the ET-50 or ET-30, press then to put the hot tub into Standby.
Press any button to take the hot tub out of standby.
Note: For ET-7 standby instructions, See page 10.