Operating instructions

Important Safety Instructions
A green colored terminal, or wire connector marked GroundGround
is provided within the control box. To reduce the risk of
electric shock, connect this terminal or connector to the
grounding terminal of the electric service or supply panel
with a continuous copper wire equivalent in size to the circuit
conductors supplying this equipment. In addition bonding lugs
are provided and marked Bonding Lugs. To reduce the risk ofBonding Lugs. To reduce the risk of. To reduce the risk of
electric shock, connect the bonding lugs in accordance with
the local electric code.
At least two lugs marked Bonding Lugs are provided on theBonding Lugs are provided on the are provided on the
external surface of the supply terminal box. To reduce the
risk of electrical shock connect the local common binding
grid in the area of the hot tub to these terminals with an
insulated or bare copper conductor not smaller than No.6
AWG. Note: this is factory installed.Note: this is factory installed.
All field-installed metal components such as rails, ladders,
drains or other similar hardware within 10 ft /3m of the
hot tub shall be bonded to the equipment grounding bus
with copper conductors not smaller than #6AWG.
CAUTION: WIRING CONNECTED IN THIS BOX
MUST BE RATED AT 600V.
There are no user serviceable parts within the
management system. The high voltage can cause injury
or death. The hot tub must be hooked up to a Ground
Fault Circuit Interrupter (G.F.C.I.) by a licensed electrician.G.F.C.I.) by a licensed electrician.) by a licensed electrician.
Use the test button on your G.F.C.I. monthly to ensure it isG.F.C.I. monthly to ensure it is monthly to ensure it is
working properly.
Always make sure there is an adequate sanitizer level in
your hot tub before entering. Failure to do so may cause
skin irritations or illness. Use a test kit or test strips to
check prior to entry.
CAUTION: WATER TEMPERATURE IN EXCESS OF
100ºF/38ºC MAY BE INJURIOUS TO YOUR HEALTH.
AVOID PROLONGED EXPOSURE TO HOT WATER.
WATER TEMPERATURE MAY NEED TO BE DECREASED
FOR CHILDREN OR THE ELDERLY.
THE MAXIMUM RECOMMENDED TEMPERATURE OF
YOUR HOT TUB WATER IS 104ºF/40ºC.
To reduce the risk of drowning from hair and body
entrapment, install suction fitting(s) with a marked flow
rate that is not less than the flow rate marked on the
remote packaged unit. Note: these are factory installed.Note: these are factory installed.
Do not operate the hot tub with any of the suction fitting
covers off. These covers prevent hair or objects from being
sucked into the plumbing. See figure 1.
IMPORTANT! READ AND FOLLOW ALL
INSTRUCTIONS AND KEEP FOR EASY
REFERENCE.
WARNING
figure 1
4