Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for
installation.
3. Slide the electrical wires through the ring(F)/tube(E)/(D)/(C) and
canopy(A) .
4. Raise the ring(F) to top screw hole of shade (G), raise the tube (E),
tube (D), tube (C) and canopy(A) to the screw pipe nipple in order,
then by turning it clockwise until tight.
5. Install the light bulbs(Not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
6. Thread the two mounting screws into the pre-drilled holes in the
Mounting plate spaced the same distance apart as the holes in the
canopy (A).
7. Attach the Mounting plate to the Junction Box with the two Junction
Box screws as shown. The side of the Mounting plate marked
"GND" must face to out. The junction box is not included.
8. While holding the fixture lamp towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape.
If your outlet has a ground wire (green or bare copper), connect the
fixture ground wire to it. Otherwise connect fixture’s ground wire
directly to the Mounting plate with the green screw provided. After
wires are connected, tuck them carefully inside the Junction Box.
9. Raise the canopy (A) on to the Junction box, aligning screws on
mounting plate with mounting holes in canopy and lock it securely
with the ball nuts(B).
Your installation is now complete. Return power to the junction
box and test the fixture.
Mountingplate
Supply
Mountingscrew
Fixture
JunctionBox
(Notinclude)
Ground
GroundWire
Wire
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2
FIG.1
Thank you for purchasing a product.
Need assistance with parts or assembly? Please call customer service.
ALL RIGHTS RESERVED.