Installation & Assembly

ASSEMBLY INSTRUCTION

NOTE: Please consult a qualified electrician if you are not certain of the installation or service.

CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker

or by removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Attach the mounting strap to outlet box using the outlet box screws provided.

3. Screw the nipple A into the bushing A using the hex nut to secure it. Place the cover and the bushing and the tube over

the nipple A. Fasten the loop to the nipple A.

4. Using two pliers twist open the links at the two ends of the chain hook one link to loop and the other link to

the screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and the chain link to prevent

scratching the link finish.

5. Weave the fixture wires up through the loop, through the chain, through the ring, through the canopy, through the

screw collar loop and through the nipple on the mounting strap.

6. Tie ground wire from fixture and from outlet box to the ground screw on the mounting strap. Position wires

back inside outlet box. Connect the wire with writing on it from fixture to the black wire from the supply

circuit. Connect the wire without writing on it (with raised ribs) from fixture to the white wire from the

supply circuit. Cover the connections using provided wire connectors.

7. Place the canopy over the nipple all the way to ceiling and tighten the ring onto the screw collar loop until

the canopy is held firmly against the ceiling.

8. Unscrew the socket rings from the sockets. Place the shades over the sockets, refasten the socket rings to secure them.

9. Install the bulbs (Included).Turn on the power.

PAGE 1
ASSEMBLY INSTRUCTION NOTE: Please consult a qualified electrician if you are not certain of the installation or service. CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. Attach the mounting strap to outlet box using the outlet box screws provided. 3. Screw the nipple A into the bushing A using the hex nut to secure it.
PAGE 2
INSTRUCCIÓN DE ASAMBLEA NOTE: Por favor, Consulte con un electricista cafificado en caso de que esté seguro de la instalación. CAUCIÓN: Antes de comenzar la instalación, cortar la electricidad mediante apagar el cortacircuitos o quitar el fusible desde la caja de fusible. 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2. Acoplar la Aro de Montaje a la Caja de Salida usando los Tornillos de la Caja de Salida que se proporcionan. 3.