Assembly Instructions

10
OPERATING (CONTINUED)
LIGHTING INSTRUCTIONS
TO LIGHT:
1. Check to make sure burner controls are in the off position. Slowly turn on the gas supply
valve.
2. Press and hold electric igniter button.
3. Turn the burner control to the high position. Press and hold until the burner lights. Release
the electric igniter button while still holding the bruner control knob.
4. Continue to depress the burner control knob for 30 seconds and then release. If the flame
goes out, repeat the procedure.
5. Adjust the flame to the desired height with the burner control knob. Visually check the
burner flames as pictured below.
Normal
6. If the burner will not light with the electric igniter, hold a lit long match or a lit long butane
lighter to the ignition area of the burner. Continue with Step 2. If the burner does not light
within 10 seconds, turn the valve off and wait 5 minutes for any gas to dissipate before
repeating the procedure.
TO SHUT OFF:
1. Turn the burner control knob to off position. Turn the gas off at the source (propane
cylinder valve).
WARNING: FOR YOUR SAFETY:
The propane cylinder is equipped with an
excess flow device. Unless burners are
turned off prior to turning the cylinder on,
only small flames and low heat will be
achievable.