EXPLODED VIEW PART LIST PART NO.
Screw bags PART NO. Description Picture A Washer 16 B Rubber gasket 2 C Screw M6*20mm 8 D Screw M6*25mm 4 E Screw M6*25mm （half a tooth） 2 F Screw M6*30mm 4 G Allen Key 1 ASSEMBLY INSTRUCTIONS Step 1 Install 2 screws (part #E) to Table base back panel (part #5) and fasten these 2 bolts .
Step 2 Install Table base back panel (part #5) to Table base right side panel (part #4) by using 2 screws #D with washers. Also install the Beam to Table base right side panel (part #4) by using 2 screws #C with washers. Don’t fasten bolts . Step 3 Install Table base left side panel (part #3) to Table base back panel (part #5) by using 2 screws #D with washers . Also install left side panel (part #5) to the Beam (part 6) by using 2 screws #C with washers . Don’t fasten bolts .
Step 4 Install Gas Tank (part#8) to the Door (part #7) by using 2 screws #F and also fasten the bolts . Locate the whole door (part #7 & part #8) to Table base left side panel (part #3) assembled with 2 screws #F ,2 Rubber gaskets (part #B) and washers by using Allen Key . Don’t fasten bolts. Step 5 Place Table top on a soft clean surface with Table bottom facing up. Install whole Table base onto bottom of Table top with 4 screws #C and washers by using Allen Key . Fasten all the bolts .
Step 6 Put Lip on the table top. Step 7 Put gas tank on the hole of the door .
Step 8 Lock the Gas tank . Step 9 Close the door.
INSTALLING LP GAS TANK Connect LP Gas Tank Before connecting, be sure that there is no debris caught in the head of the LP gas tank, head of the regulator valve or in the head of the burner and burner ports. Connect regulator/hose assembly to tank by turning knob clockwise stops. LP GAS Disconnect LP Gas Tank Before disconnecting make sure the LP gas tank valve is "CLOSED". Disconnect regulator/hose assembly from LP gas tank by turning knob counterclockwise until it is loose.
LEAK TESTING WARNING: Before using this outdoor fire pit, make sure you have read, understand and are following all information provided in the Dangers and Warnings. Failure to follow those instructions can cause death ,serious injury or property damage. WARNING Never use your fire pit without leak testing all gas connections, hoses and propane tank. DANGER ♦ ♦ ♦ ♦ To prevent fire or explosion hazard: DO NOT smoke or permit ignition sources in the area while conducting a leak test.
BATTERY INSTALLATION 1xAAA Battery (Battery not included) Put correct Battery in before use.
Step2 Put the Lip on the screw that of Table base back panel for storage.
LIGHTING INSTRUCTIONS Caution: Keep outdoor gas cooking appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. Caution: Do not obstruct the flow of combustion and ventilation air. Caution: Check and clean burner/venturi tubes for insects and insect nests. A clogged tube can lead to a fire beneath the grill. Caution: Attempting to light the burner with the lid closed may cause an explosion. Lighting 1. Read instructions before lighting. 2.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Propane cylinder is empty Replace propane cylinder Blockage in orifice Clear blockage Control knob is not in ON position Turn control knob to ON Gas pressure is low Turn cylinder valve OFF and fill the cylinder Outdoor temperature is less than 40ºF and tank is less than 1/4 full Use a full cylinder Control knob fully ON Check burner and orifices for blockage Carbon build-up Dirt or film on reflector and burner screen Clean reflector
CARE AND MAINTENANCE CAUTION: All cleaning and maintenance should be done when fire pit is cool and with the fuel supply disconnected. 1. DO NOT clean any outdoor fire pit part in a self cleaning oven. The extreme heat will damage the finish. 2. Do not enlarge valve orifices or burner ports when cleaning the valves or burners. Notices 1. This outdoor fire pit should be thoroughly cleaned and inspected on a regular basis. 2. Abrasive cleaners will damage this product. 3.
