Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out
all the parts on a clear area. Take care not to lose any small parts
necessary for installation.
2. Return the arms to suitable position, see figure.1.
3. Slide the electrical wires through the pipe thread(M) to the top coupling of
lamp body(N), lock it with the end of hex nut. Slide the tube(L) and cover
nut(K) to the pipe thread(M), lock it with the cover nut until tight.
4. Raise the end of pipe thread (C) into coupling, lock it with the hex nut until
tight. Raise the other end of pipe thread(C) into single bar (D), place lock
washer (B) over the end of thread protruding through single bar and lock it
securely with the hex nut (A).
5. Slide the electrical wires through the tube(J)/(I)/(G)/ring(H)/canopy(F) and
assembled single bar(D).
6. Raise the tube (J) to the end of pipe thread(M), raise the tube (I)/(G) and
assembled single bar(D) to the screw pipe nipple in order, then by turning
it clockwise until tight. Raise the glass shade(P) insert the lamp holder,
lock it securely with the check ring(O).
7. Install the light bulbs(Not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
8. While holding the assembled single bar(D) of fixture body to the ceiling
junction box with junction box screws (E) as shown, tighten screws
securely with screwdriver. The side of the single bar marked "GND" must
face out. The junction box is not included.
9. Connect the electrical wires as Shown in Fig.2, making sure that all wire
nuts are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper), connect the
fixture ground wire to it. Otherwise connect fixture’s ground wire directly to
the single bar with the green screw provided. After wires are connected,
tuck them carefully inside the Junction Box.
10. Slide the canopy onto the Junction box, lock it securely with the ring(H)
until tight.
Your installation is now complete. Return power to the
junction box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2 FIG.1
©COYRIGHT ALL RIGHTS RESERVED.
Thank you for purchasing our product.
Need assistance with parts or assembly? Please call customer service