Installation & Assembly

ManualsBrandsBeachcrest Home ManualsCeiling LightsAkini 1 - Light Single Bell Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Installation Steps

Mounting Strap (A)

Mounting Screw (B) Wire Connector (C)

Fixture Mounting Screw (D)

Lock Nut (E) Ball Nut (F)

Fixture Canopy

Ball Nut (F)

Upper Rod

Threaded Pipe

Middle Rod

Lower Rod

Socket

Glass Shade

Socket Ring

Outlet Box

House Ground Wire

Wire Connector (C)

Fixture Mounting Screw (D)

Mounting Strap (A)

Green Ground Screw

Lock Nut (E)

Mounting Screw (B)

Threaded Pipe

Type A Max 60W

or ST Vintage Bulb

(not included)

1. Thread two fixture mounting screws (D) through the mounting strap (A),

then secure with two lock nuts (E). Adjust the length of the fixture

mounting screws (D) if necessary.

2. Attach the mounting strap (A) to the outlet box by using two mounting

screws (B).

3. Rod connections:

a. Thread the fixture wire from the fixture through the lower rod,

then secure the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, then secure the

middle rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, then secure the

upper rod onto the middle rod using the threaded pipe.

d. Thread the fixture wire through the canopy, then secure the

canopy onto the upper rod using the threaded pipe.

Note: Length dajustable from 10-1/4” to 55-1/4”. Use fewer rods

if shorter length is desired.

4. Pull out the source wires from the outlet box. Make wire connections

using wire connectors (C) as follows:

---Connect the smooth-coated wire (marked) from the fixture to the

black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the fixture to the

white wire from the power source.

---Attach the fixture ground wire to the mounting strap (A) with the

green ground screw, then connect it to the house ground wire

with a wire connector (C).

Carefully put the wires back into the outlet box.

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Attach the fixture canopy to the mounting strap (A) by inserting the fixture mounting screws (D), then secure it with two ball nuts (F). 6. Attach the glass shade onto the socket and tighten the glass shade with the socket ring. Fig. 1 Support Brace Outlet Box 7. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage. Canopy Coupling Kit 8. Angled mounting recommended for a vaulted or angled ceiling. (See Fig.