Assembly & Installation Instructions

ManualsBrandsBeachcrest Home ManualsCeiling LightsAkini 1 - Light Single Bell Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES 1 Before installing consult local electrical codes for wiring and grounding requirements:. , .

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK BE SURE TO SHUT OFF,

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Mounting Strap A()

Green Grounding

Screw E()

Fixture Mounting

Screw D()

Mounting Screw B()

Wire Connector C)(

Lock Nut F()

Fixture Canopy

Ball Nut G()

Upper Rod

Threaded Pipe

Middle Rod

Lower Rod

Socket

Glass Shade

Socket ring

Outlet Box

House Grounding Wire

Wire Connector (C)

Fixture Mounting Screw D()

Mounting Strap A()

Green Grounding Screw E()

Lock Nut F()

Mounting Screw B()

Threaded Pipe

Type A Max 60 W.

or ST Vintage Bulb

()not included

1 Thread two fixture mounting screws through the mounting.

strap, and then secure with two lock nuts. Adjust

the length of the fixture mounting screws if necessary.

2 Attach the mounting strap to the outlet box by using two.

mounting screws.

.:Rod Connections

a. Thread the fixture wire from the fixture through the

lower rod, and then secure the lower rod onto fixture

using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then

secure the middle rod onto the lower rod using the

threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure

the upper rod onto the middle rod using the threaded pipe.

4 Pull out the source wires from the outlet box Make wire..

connections using wire connectors as follows:

---Connect the smooth-coated wire (marked) from the fixture to

the black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the fixture to

the white wire from the power source.

---Attach the fixture grounding wire to the mounting strap with

the green grounding screw, and then connect it to the

house grounding wire with a .wire connector

Carefully put the wires back into the outlet box.

d Thread the fixture wire through the fixture canopy and then secure.,

the fixture canopy onto the upper rod using the threaded pipe.

Note Length adjustable from 10 1 4 to 55 1 4 Use: -/" -/".

fewer rods if shorter length is desired.

Hardware Package included():

2. READ AND SAVE THESE INSTRUCTIONS.

Installation Steps