IMPORTANT * Do riot tighten up all the screwdriver until each part fs properly assembled. * Yau should keep Hex Wrench in a safe place as you ma; * After assembly item must be level to work properly. Us y need to tighten up the Head Cap Bolts in the vulture, © the included adjustable levelers to level. STEP 1 Wood Attach Top (A1) to Top (A2) with Wood Screws. Put Cam Lock Screws into the per-drilled holes of Top (A1), Side Panel (D), (5), (F), (G) and tighten.
STEP 2 Attach Side Panel (B) to Base (P) with Head Cap Bolts. Attach Side Panels (D) and (E)to Base (P) with Head Cap Bolts. (see Figure 1) STEP 3 Attach Front All (H1) and Front-Rail (H2) to unit .using Cam Locks. (seé Figure 1) Almach Back Stretcher (I) to unit using Cam Locks. Slide Back Panel (K) into Place. Attach Stretcher (J} to unit then slide Back Panel Ky a : into place.
STEP 4 Attach Side Panel (C) tc Base (P) with Head Cap Boris. Attach Side Panels (F) and (G) to unit with Head Cap Bolts. Head Cap Bolt STEP 5 * Attach Plinths (Q) to Bass (P) with Head Cap Bolts. Almach Plinths (Sy and Leg Support (R) to withdrawn Head Cap Bolts.
Wood Screw STEP 6 Attach Back Support (N) and 0) to unit with Wood Screws info per-drilled holes. Figure STEP 7 of > Place Top (A) onto unit with Cam Locks. Adjustable Pin Attach Doors (T) and (U) by sliding the door lift hinges into the side panels lift hinges. (see Figure Assemble Pull Handles to Doors (T) and (U) with Mariachi Screws. (see Figure 2) . . Insert Adjustable Pins into side panels at the desired level, then place Shelves (L) and (M) into position. Slide the Drawers (V) into position.
Almach V1 to V3 and V4, using : a Phillips screwdriver and img long wood screws (4X), TS lighten halfway. MAKE SURE ROLL Attach V2 to V3 and v4 using {SON THE Bach long wood screws (4X), STEP 2 tighten halfway. (see Figure 1) Slide V5 into the grooves in V3 and V4. Be sure to push V5 all the way forward to it meets V1. (see Figure 2) STEP 4 Almach hardware pulls with machine screws. (see Figure 4) STEP 3 Insert short wood screws (6X) into the per-drilled holes in V5, tighten screws.
