User's Manual

Quick Setup Guide
1) Ensure the POWER switch is set to OFF before you begin.
2) Install a fresh alkaline or lithium battery in the adapter.
3) Mount the DXA-SLR ULTRA adapter to the camera.
4) Connect the supplied output cable from the OUT jack on the
adapter to the MIC input jack on the camera.
5) Connect your microphones or other audio sources to the adapter
XLR inputs.
6) Set the GAIN switches to HI.
7) Set the LIMITER switches to ON.
8) Set the MONITOR switch to REC.
9) Set the LIN/MIC/PH switches to:
a) MIC for self powered microphones or wireless systems
b) PH for microphones that require phantom power
c) LIN for mixers
DO NOT activate phantom power when attaching wireless
microphones!
10) Set the PH VOLTAGE switch as follows:
a) OFF if phantom power is not required on either channel
b) 48V if mics on either channel require 48 volt phantom power
c) 12V if the mics can operate on 12 volts to save on battery
power
11) Set the M/S switch to M for mono when using one channel or to S
for stereo when using two channels.
12) Turn the adapter PWR switch on. The power LED should indicate
green.
2