Operation Manual
11
3. Getting Started
3.1. Batteries
The battery is included in the package. It is not fully charged out of factory but it may still be able to power on your phone. Please
completely use up the power of the battery and then charge it for at least 12 hours with your phone turned off. You battery will reach
its optimal state after three cycles of charge and discharge.
3.1.1. Installing and uninstalling the battery
To install the battery, remove the back cover from the phone by pressing firmly on the cover and slide it down. Align the golden
contacts of the battery to the contacts in the phone, and then gently snap down the battery into place. Re-assemble the back cover.
To uninstall the battery, flip the battery out from the bottom of the battery.
3.1.2. Charging the battery
Plug the charger into the socket on the side of your phone. Connect the charger to an AC wall socket. The blinking of the battery level
icon indicates the battery is being charged. When the blinking stops, it indicates the charging is finished
During charging, the phone and charger will feel warm to the touch. This is normal.
3.1.3. Turn ON/ OFF the phone
For switching ON : press for several seconds, the red call key
For switching OFF : press for several seconds, the red call key until the screen is switched off.
Warning:
The operating ambient temperature of the charger is 0C-50C. Do not use it when the temperature exceeds this limit.
Use only chargers approved by the phone manufacturer to ensure safety. Failing to comply with this will violate the terms and
conditions of the warranty.
3.1.4. Using the battery
The waiting time and calling time capacities specified by the phone manufacturer are obtained under the ideal operating environment.
The actual values will vary with the network condition, operating environment and operation method.