User's Manual

%($07HUUD,QVWDOODWLRQ8VHU0DQXDO

056#..#6+10241%'&74'
056#..+0)6*''44#LNN
The following sections detail the installation of
the Terra 800.
1. Install the antenna
2. SIM installation
3. (A) Wall mounting orientation
(B) Desk mounting orientation
4. Privacy handset and mounting cup
5. Access to rear connector bay
6. Connect POTS/RJ11 interface
7. Auxiliary connection (optional)
8. IO connection (optional)
9. Connect USB
10. Connect power cable
11. Cable routing
12. Water resistant IP54 rating
13. Conguration settings
Ek056#..6*'#06'00#
To connect the Terra 800 to the antenna, requires
the use of certied satellite and GPS antenna
cables. These purpose built cables are approved by
BEAM to manage the power requirements for the
antenna system. The full list of approved cables
can be found at:
www.beamcommunications.com/terra800
1. Refer to the antenna’s installation guide
for antenna mounting and location
requirements.
2. Run the antenna cables from the Terra 800
to the antenna.
3. Connect the antenna cable labelled “GPS” to
the SMA antenna connector labelled “GPS”.
4. Connect the antenna cable labelled
“Inmarsat” to the SMA antenna connector
labelled “ISAT”.
5. Connect the GPS-SMA (Female) cable end
to the Terra 800’s SMA connector.
6. Connect the TNC (Female) antenna cable
end to the Terra 800’s satellite connector.
Antenna connection diagram for TR800
Directional/Fixed antenna (passive)
65
43
TNC
SMA
SMA
SMA
Satellite
Antenna
Cable
GPS
Antenna
Cable
7+,66,'(83