User's Manual
%($07HUUD,QVWDOODWLRQ8VHU0DQXDO
Locking bolt
Once the Terra 800 has been secured onto the
mounting plate, a locking bolt prevents the
terminal separating from the mounting plate.
There is one locking bolt used when wall
mounting the terminal.
1. Remove the mounting cup (see the
following section 4)
2. Insert the bolt into the hole shown and
screw into place
3. Ensure the terminal will not slide up off
the mounting bracket
4. Replace the mounting cup.
G$k'5-/1706+0)14+'06#6+10
The Terra 800 supports a desk mount
conguration. The unit supports both a at and
raised orientation on the desk.
Inclined desk installation
1. Behind the terminal are two retractable feet
2. Flip the feet out if required to give
elevation from a desk.
Flat desk installation
1. Stick the two rubber feet onto the bottom of
the terminal as shown below.
a
b c
Slide the terminal
down to “lock”
Fit the 3 hooks of the mount bracket into the large
mounting holes on the back of the terminal
Final “lock” position