User's Manual
Hk4+8#%;*#0&5'6n/1706+0)%72
The privacy handset is part of the Terra 800,
providing a local handset function.
The privacy handset connects to the rear of
the Terra 800 via a RJ9 connector. The privacy
handset is connected beneath the rear panel of
the Terra 800. Once connected, the cable should
be run out through the foam and placed in the
‘S’ channel through the base of the terminal as
illustrated below:
Mounting cups
There are two unique mounting cups for the
privacy handset. (1) springless cup for either
a desk mounted position or a wall mounted
position. (2) spring cup for rough environments.
(1) Springless cup for normal light-use
desk mounted cradle position.
The ‘springless’ cup is shown tted to the Terra 800
with the mounting clip in a ‘ush’ position.
Wall mounted cradle position.
The mounting clip can be slid out and
reversed, revealing a protruding edge that
the privacy handset rests upon. For a wall
mounted terminal this retains the privacy
handset while allowing the handset to be
easily removed when in a call.
Changing cups
1. Unhook the privacy handset from cup.
2. Use a at screw driver in one of the two
side slots to leaver the cup cover out
exposing the 3 screws.
3. Unscrew 3 screws with a phillips screwdriver.
4. Detach the cup and replace with the
spring or springless cup.
NOTE
When the cup is removed this will expose the locking
bolt screw hole. (Refer to ‘Locking bolt’ on page 19.)
1
2
3
4