User's Manual


Conguration Using Remote Commands
Conguration instructions or “Remote
Commands” can be sent to the terminal via
SMS, and most settings are supported that are
normally accessible from Falcon. Please refer
to the Falcon user manual for more information.
NOTE
Due to memory limitations it is recommended
that users have no more than 20 SMS messages
in their inbox. If this amount is exceeded the
processing of remote commands and the ability
to retrieve the messages via the Falcon tool may
be compromised.
EGk10(+)74#6+105'66+0)5
The Terra 800 terminal is ready for you to make
voice calls as soon as it is registered. If you wish
to customise the operation of your Terra 800 the
Falcon application is required. This rst step is to
install the BEAM USB driver.
USB driver installation
Terra 800 terminal USB data port requires
an interface driver to be installed on the
user’s computer prior to undertaking data
communication. This driver supports the
following operating systems:
Windows XP (SP3 or above) & Windows 7
The Windows driver for the Terra 800 is
contained in the Falcon software download.
If required separately, the USB driver can be
downloaded from:
www.beamcommunications.com/falcon
NOTE
MAC OS is not supported by this software.
Conguration using Falcon
Falcon can be downloaded from:
www.beamcommunications.com/falcon
Follow the instructions in the downloaded
application to install. Once complete, connect
your PC to the USB port of the terminal and start
Falcon. You can then use the application for a
range of options such as:
• View the status of the unit
• Congure POTS settings
• Send/receive SMS
• Resetting factory defaults
• Store/edit/retrieve settings
• Modifying supervise PIN
• BEAM terminal rmware upgrade
• Inmarsat transceiver rmware upgrade
• Enable/disable SIM PIN