User's Manual

%($07HUUD,QVWDOODWLRQ8VHU0DQXDO

Options:
A. During a call, you may switch to
“speakerphone” mode by pressing the
speakerphone button on the terminal.
Return the privacy handset to its cup.
B. To return the call back to the privacy handset,
remove the privacy handset from its cup.
Mobile terminating
1. Answer the incoming call by un-cupping
the privacy handset from its cup.
2. Press the RED key on the Terra 800 keypad
or return the privacy handset to its cup to
terminate the call.
76'/1&'
Mute functionality
The mute function of the Terra 800 allows the
user to mute the uplink microphone audio on
the privacy handset and/or internal handsfree
microphone.
1. During a call, press the mute button on
the front of the Terra 800, a RED LED will
illuminate the mute button to conrm that
the uplink audio is muted.
2. To exit the mute mode, press the mute
button once.
EEf2*10'75'
Mobile originating
1. Lift the RJ11/POTS phone handset “OFF
HOOK” and listen for the dial tone. The call
LED will ash GREEN to indicate the RJ11/
POTS is in use.
2. Dial (using the full country codes) on the
RJ11/POTS telephone keypad.
3. Once the call is connected, the POTS status
LED will ash to indicate a call is in progress.
4. Place the RJ11/POTS phone handset “ON
HOOK” to terminate the call.
Mobile terminating
1. The RJ11/POTS phone will sound its ringer.
2. Lift the RJ11/POTS phone handset “OFF
HOOK” to answer the call.
NOTE: (default operation)
For mobile terminated calls, the call will remain
active for ~90 seconds even if the RJ11/POTS
phone is placed ON HOOK. To end the call
immediately, the other calling party must hang
up (ON HOOK) the call.
Data use
Ensure that you have installed the BEAM USB
driver – see section “Conguration Settings ”
(shown on page 26).
The Terra 800 terminal allows for circuit
switched data via the BEAM USB data port
that is presented when plugged into your PC.
Follow the normal procedures with your data
application to connect. Once connected, the
Call LED will be flashing YELLOW. Once the
circuit switched connection has ended, the
Call LED will turn off.
NOTE: During a data connection, the RJ11/POTS
handset cannot make or receive voice calls. An
unavailable tone will be heard on the RJ11/
POTS handset.