Technical data
4
1. GENERAL SAFETY INFORMATION
1.1. Purpose of this manual
This installation, use and maintenance manual are an integral and essential part of the BEAM
Commercial Central Vacuum unit.
Its purpose is to provide all necessary information to allow the installer to install the system in full
compliance with the manufacturer’s specications, the user to operate the system in the safest
and most independent way, and maintenance technicians carrying out programmed maintenance
operations to ensure the correct operation of machinery and the system as a whole.
The manufacturer declines all liability for damage deriving from failure to observe the instructions
given in this manual. In case of doubts on the correct interpretation of instructions, contact your local
distributor/dealer to receive the necessary explanations.
1.2. Composition of the manual and consultation details
This installation, use and maintenance manual are composed of chapters divided into sections,
identied by a progressive numbering system at the start of each different topic. The table of contents
lists the chapters and sections, allowing the desired topic to be easily found.
The descriptions and illustrations provided in this manual are not binding. BEAM Electrolux reserves
the right to make any modications it deems necessary at any moment, without any obligation for
prior notication.
1.3. General safety precautions
The purpose of this information is to make persons interacting with the system aware of all possible
conditions of danger, and thereby to avoid injuries either to themselves or to others.
Design for safety
During the design and construction phase, the manufacturer dedicated particular attention to aspects
that may cause risks for the safety or health of persons using the system.
In addition to complying with applicable laws, the manufacturer followed all rules for Good
Manufacturing Practices.
Nevertheless, some parts of the system could cause risks that are not immediately evident. It is
therefore advisable to take particular care during use of the system and during routine maintenance
operations.
Safety during use
Before starting to use the system in any way whatsoever, the instructions given in this manual
supplied must be read carefully and completely, together with the indications provided directly on the
system with safety warning symbols.
Do not tamper with, bypass or remove the safety devices installed on the system.
Failure to observe these instructions may cause risks for the safety or health of persons.
Safety during maintenance
Personnel carrying out any kind of routine maintenance on the system during its entire lifespan must
possess specic technical skills, special capacities and acquired experience recognized in the sector
in question.
The absence of these requisites may cause risks for the safety or health of persons.