User manual
IsatDock DRIVE - Installation & User Manual
25
IsatDock DRIVE Front Panel
Location Button
Mode
Action LED/Sound
Mute Press
on/o
In a Call:
Mute the microphone (uplink) on the privacy handset
(optional accessory) if connected to cradle.
LED turns RED - Muted
LED turns OFF - Not muted
Up In a Call:
Increase volume on the external speaker or privacy handset
(optional accessory) if connected to cradle.
Audio will sound louder in privacy handset with each press.
Out of Call:
Increase volume of incoming ring tone on the external speaker.
A beep will sound indicating the increased ring tone volume .
Down In a Call:
Decrease volume on the external speaker or privacy handset
(optional accessory) if connected to cradle.
Audio will sound quieter in privacy handset with each press.
Out of Call:
Decrease volume of incoming ring tone on the external speaker.
A beep will sound indicating the decreased ring tone volume .
Single Press
(1 second)
In Tracking Mode*:
Send a tracking message to the pre-congured destination
LED changes from RED (solid or ashing) to solid GREEN if GPS x acquired
Otherwise, LED ashing in GREEN.
One beep will sound if enabled in IDMS.
Single Press
(7 seconds)
In Alert/Emergency Mode*:
Clear the alert/emergency mode and return to the
Tracking mode*.
LED changes from RED (solid or ashing) to solid GREEN if GPS x acquired
Otherwise, LED ashing in GREEN.
One beep will sound if enabled in IDMS.
+
Two button
press
(2 seconds)
In Tracking Mode*:
Activate the Alert/Emergency mode.
Track LED changes from GREEN (solid or ashing) to solid RED when the alert is
triggered. A beep will sound if enabled in IDMS
Track LED will then ash in RED when the alert message is sent.
Track LED will nally ash YELLOW when the alert is acknowledged.
+
Brightness
dual button
simultaneous
press
Out of Call:
Enter LED brightness change mode. Press UP and DOWN
arrows to vary intensity. Mode will automatically exit after 5
seconds after the last button press.
All LED’s will change to WHITE and a single beep will sound when entering
brightness change mode.
A short double beep will sound when exiting change mode.
* This action is optional, only when the Tracking Mode for your IsatDock DRIVE is congured and activated.