User manual

IsatDock PRO - Installation & User Manual
2120
5) Connect RJ11/POTS Interface
Any standard analogue POTS Telephone (POTS =
Plain Old Telephone Service) is supported by the
IsatDock PRO. It supplies power to the analogue
phone as well as ring, dial and busy tones.
Route the telephone cabling (up to 600m) from
the analogue phone.
Mount the analogue phone if required, and plug
the RJ11 cable into the IsatDock PRO RJ11 port.
RJ11 port
See section 4 on page 19
6) USB Port Connection
IsatDock PRO has a micro USB Data Port for
programming interface to enable upgrading of
the Docking station rmware.
USB Data Port
See section 4 on page 19
7) Connecting Power to the Dock
The Dock can be powered from the supplied AC
Plug pack, or connect to an external 10-32V DC
power supply.
ISD950 AC Plug Pack Installation
For installation using ISD950 110-240 AC plug
pack, connect the 4-way Microt connector from
the plug pack to the 4-way power connector on
the rear of the IsatDock PRO. In this conguration
the ignition/accessory status is always ON.
DC Power Source Installation
The DC power cable has three wires, RED,
BLACK and YELLOW. The RED and BLACK wires
are used for the power connection while the
YELLOW wire can be connected to a vessels
accessories, ignition or other similar circuits to
control the ON/OFF status of the IsatDock PRO
in synchronization with a vessels operation.
By default, the IsatDock PRO will stay on for 20
minutes after this input (YELLOW wire) is switched
o. If a call is in progress while this occurs, the
IsatDock PRO will stay on for 20 minutes after the
call is terminated. Please follow the steps below to
connect the DC power cable to the vehicle battery
power and the IsatDock PRO.
1. Route the wire end of the DC power cable
to the connection point.
2. Connect the BLACK wire to the negative
terminal of the battery (10A fuse
recommended) or the vehicle chassis (if
negatively grounded chassis).
3. Connect the RED wire to the positive
terminal of the battery. It is recommended
to add the 5A fuse (supplied) between
them.
4. Connect the YELLOW wire to the vehicle
accessory power. If the accessory power
is unavailable, this may be connected
to a vehicle ignition voltage. It is
recommended to add a 1A fuse between
them. The accessory wire enables the
IsatDock PRO to turn on and o as the
vehicle key is enabled or disabled. If this
function is not required, the YELLOW wire
MUST be connected to the RED wire.
5. Connect the 4-way Microt connector on
the DC power cable to the 4-way power
connector on the rear cable loom of the
IsatDock PRO.
YELLOW
BLACK
RED
RED (+) Vin 10 to 32VDC
BLACK (-) OV Power Ground
YELLOW ON/SLEEP
To Battery Positive Terminal
(Requires 5A Fuse)
To Negative Terminal or chassis
To ON/OFF switch
(1A Fuse recommended)